I've been working on an office desk in ecabs for a week or so and did some mods for the customer last night for a meeting today and I sent it to the printer and it never printed. Now I can't load my job in custom layout or any of my previous jobs either. I can however load cabs in the cabinet editor.
Any ideas would be appreciated.
Thanks
Joseph
custom layout probs
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 28
- Joined: Fri, Feb 23 2007, 9:40AM
more on layout probs
As I continue to see if I can figure this out now I'm able to load other jobs but not the one I want to. A dialog box opens and tells me that multiple thicknesses for the same part exists. When I look in my materials I can only find one thickness for the part it mentions.
Joseph
Joseph
-
- Junior Member
- Posts: 28
- Joined: Fri, Feb 23 2007, 9:40AM
-
- Wizard Member
- Posts: 5852
- Joined: Thu, Jul 28 2005, 10:18AM
- Company Name: Dan Epps
- Country: UNITED STATES
- Location: Rocky Face GA
See if this one works for you. I changed all meterials to generic ans was able to regenerate the components made from 1-1/2\" Red Oak. That is what was causing your problems...it thought there was 2 different thicknesses for it--.8125\" and .813\".
- Attachments
-
- teske_reception_186.esj
- (4.17 MiB) Downloaded 258 times
-
- Junior Member
- Posts: 28
- Joined: Fri, Feb 23 2007, 9:40AM
Re: custom layout probs
Thgat did it, thanks a lot Dan, you are the wizard!
Joe-
Joe-