wall end panel inset from faceframe edge

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
michael taylor
New Member
Posts: 15
Joined: Wed, Jan 09 2008, 2:35PM

wall end panel inset from faceframe edge

Post by michael taylor »

we are wondering how to offset a wall end panel back from outside edge of faceframe dimension. we dont make our faceframes on the cnc so we like to allow for alittle space.
Brian Widiker
New Member
Posts: 23
Joined: Fri, Dec 14 2007, 10:36PM
Location: Cameron WI

Re: wall end panel inset from faceframe edge

Post by Brian Widiker »

Michael
Go to construction setting and change you faceframe setting under outside scribe .
good luck i'm new to but you will find alot of help on this forum.
brian :wink:
Brian
Post Reply