Lights below floor. Help!

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

User avatar
Brian Bauer
Guru Member
Posts: 365
Joined: Tue, Sep 20 2005, 8:22PM
Location: Lower Lake, California
Contact:

Lights below floor. Help!

Postby Brian Bauer » Sat, Jan 26 2008, 8:51PM

Hello all,
Not sure where this new problem came from the lights worked fine before ,now they come in under the finished floor.can anyone tell me where the setting for default height is set at? looked high and low can't find it.Does it exist? Or did I just walk into the twilight zone? Confused on a saturday.
Brian Bauer
Wood is wood , Particle Board is just dust !

Douglas Walters
Junior Member
Posts: 44
Joined: Mon, Mar 13 2006, 6:35PM
Location: Sussex WI

Re: Lights below floor. Help!

Postby Douglas Walters » Sat, Jan 26 2008, 9:34PM

Hi Brian,
I think the lights are set at the height of the last wall setting if I am not mistaken.
Hope this helps.
Doug
D Walters
Wood Architects

User avatar
Brian Bauer
Guru Member
Posts: 365
Joined: Tue, Sep 20 2005, 8:22PM
Location: Lower Lake, California
Contact:

Re: Lights below floor. Help!

Postby Brian Bauer » Mon, Jan 28 2008, 1:58AM

Thanks,Doug
That was it.I had a cutout in the wall with a sliver left at the bottom and the lights set to that height.DOH

So much for a guru member :wink:

Thanks Brian
Wood is wood , Particle Board is just dust !


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: Majestic-12 [Bot] and 10 guests