Hello all,
Not sure where this new problem came from the lights worked fine before ,now they come in under the finished floor.can anyone tell me where the setting for default height is set at? looked high and low can't find it.Does it exist? Or did I just walk into the twilight zone? Confused on a saturday.
Brian Bauer
Lights below floor. Help!
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Guru Member
- Posts: 365
- Joined: Tue, Sep 20 2005, 8:22PM
- Location: Lower Lake, California
- Contact:
Lights below floor. Help!
Wood is wood , Particle Board is just dust !
-
- Junior Member
- Posts: 44
- Joined: Mon, Mar 13 2006, 6:35PM
- Location: Sussex WI
Re: Lights below floor. Help!
Hi Brian,
I think the lights are set at the height of the last wall setting if I am not mistaken.
Hope this helps.
Doug
I think the lights are set at the height of the last wall setting if I am not mistaken.
Hope this helps.
Doug
D Walters
Wood Architects
Wood Architects
-
- Guru Member
- Posts: 365
- Joined: Tue, Sep 20 2005, 8:22PM
- Location: Lower Lake, California
- Contact:
Re: Lights below floor. Help!
Thanks,Doug
That was it.I had a cutout in the wall with a sliver left at the bottom and the lights set to that height.DOH
So much for a guru member
Thanks Brian
That was it.I had a cutout in the wall with a sliver left at the bottom and the lights set to that height.DOH
So much for a guru member
Thanks Brian
Wood is wood , Particle Board is just dust !