door question?

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Darren Harvey
Junior Member
Posts: 68
Joined: Fri, Jun 23 2006, 9:01AM
Location: palm harbor, fl

door question?

Post by Darren Harvey »

i'm trying to do a rout in my doors. the question is how do you do it, and gt it a nest. i'm using slab doors.
Justin Melhiser

Re: door question?

Post by Justin Melhiser »

Darren

Slab doors can be taken in to the part editor to apply any machine operations you are wanting on the door.
Kerry Fullington
Wizard Member
Posts: 4718
Joined: Mon, May 09 2005, 7:33PM
Company Name: Double E Cabinets
Country: UNITED STATES
Location: Amarillo, TX

Re: door question?

Post by Kerry Fullington »

Darren,

I have always used the MDF door selection (with whatever material I really want to use) if I am doing part editor edge cuts because I haven't found a way to remove the edge banding where it doesn't show. I created an edgebanding called NONE with a 0" width and 0" thickness but it still shows after you run an edge profile using a slab door.


Kerry
Post Reply