Is it possible to import ".x_t" parasolid file extenssions into eCab as a display item?
I remember reading a thread discussing this issue and can not find it.
Importing Parasolids?
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Robert Williams
- Junior Member
- Posts: 25
- Joined: Tue, Jan 02 2007, 5:57PM
- Location: Georgia
-
Robert Williams
- Junior Member
- Posts: 25
- Joined: Tue, Jan 02 2007, 5:57PM
- Location: Georgia
Re: Importing Parasolids?
I just noticed several threads down there is a similar topic, I'll take a look at accutran 3d and see if it can convert it to .stl.
-
Dan Voges
Re: Importing Parasolids?
Parasolid files can only be used in the contour mode of part editor. You can bring in a display panel and then apply your parasolid file to that to give you your display part.