I need help! Can't think. I'm trying to build a drawer box and I want the front and back dadoed 1/8" into the sides. I want the bottom dadoed 1/4" into the front and sides. The back is not dadoed, it sits on top of the bottom. Which settings do I set to what to get what I want?
Ron
Drawer box
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 48
- Joined: Tue, Jan 08 2008, 8:04PM
- Location: Louisville, GA
-
- Junior Member
- Posts: 48
- Joined: Tue, Jan 08 2008, 8:04PM
- Location: Louisville, GA
Re: Drawer box
I think I got it figured out.
Ron
Ron
Re: Drawer box
In the drawer box designer, (what loads when you select your drawer box to be a cabinet default) you have to go to the construction settings inside the drawer box designer and then go into the appropriate tabs for what you want to change. (ie: go into the BOTTOM tab, set the placement of the bottom for BACK FLUSH, etc). After you are happy with the changes you made, you can then save that drawer box so you don't have to make those changes all the time.