I have an entire kitchen originally designed with butt joint drawers. The customer wanted dovetails. No problem, says I. In Room Detail I selected all the cabinets and changes all the drawer boxes from my butt joint box to my Dovetail joint box.
Now when I go to print the nesting sheets it tries to print two extra sheets of my birch plywood for every sheet that is shown on the screen. I need 12 sheets of birch plywood for my boxes and when I print it tries to print 36 sheets.
Help!
I even did a "save as" with a new name deleted all but one set of cabinets. Took one of the cabinets into the cabinet editor, deleted the drawers and boxes and then added them back. Returned to the room and tried to nest. The same thing is happening.
Drawer box nesting/printing problem
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Senior Member
- Posts: 222
- Joined: Sun, Dec 11 2005, 1:22PM
- Location: Kennedale, Texas
- Contact:
-
- Senior Member
- Posts: 222
- Joined: Sun, Dec 11 2005, 1:22PM
- Location: Kennedale, Texas
- Contact:
Re: Drawer box nesting/printing problem
Oh yea to make things worse, the sheets that contain the drawer parts show up about an inch square on the page.
Lamar Horton
http://www.jlcustomcabinets.com
http://www.jlcustomcabinets.com
Re: Drawer box nesting/printing problem
Lamar
Would you like to send me this job file? I will test it here and see if I get the same results.
Would you like to send me this job file? I will test it here and see if I get the same results.