drawer front not registering and weinscting problems
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- New Member
- Posts: 16
- Joined: Mon, Jan 23 2006, 10:22PM
- Company Name: mark cherry cabinets
- Country: UNITED STATES
- Location: allenton,WI
- Contact:
drawer front not registering and weinscting problems
Hi All Im having a problem with my drawer fronts not being added to the cost sheet,the image shows the fronts on the drawings,I wonder if I have somthing not set up right.I also am having problems setting aframed panel on a wall for weinscoting it gets added to the cost sheet but cant be seen. What am I doing wrong. thanks mark
Re: drawer front not registering and weinscting problems
Mark,mark l cherry wrote:Hi All Im having a problem with my drawer fronts not being added to the cost sheet,the image shows the fronts on the drawings,I wonder if I have somthing not set up right.
When choosing your door/drawerfront make sure the "Alternate Source" radio button in selected. Then add the doors/drawerfront. This should allow the doors/drawerfront to appear on the cost sheet.
Where are you adding the A-framed panel?mark l cherry wrote:I also am having problems setting aframed panel on a wall for weinscoting it gets added to the cost sheet but cant be seen. What am I doing wrong. thanks
- Layout Editor?
- Cabinet Editor?
- Batch Editor?
-
- New Member
- Posts: 16
- Joined: Mon, Jan 23 2006, 10:22PM
- Company Name: mark cherry cabinets
- Country: UNITED STATES
- Location: allenton,WI
- Contact:
Re: drawer front not registering and weinscting problems
Hi Todd ,thanks for the reply. I was building the weinscoting in the cabinet editor. I finely got it to show up by adding some sides to the frames, 1/16 inch,deep. the drawer front solution worked, thanks again mark.