Positioning water pipe

Mike Snodgrass · Post by **Mike Snodgrass** » Wed, May 07 2008, 9:25PM

When I select the water pipe in elevation view. It no longer shows up in the positioning boxes. What can I do to get the correct positioning?

Rick Palechuk · Post by **Rick Palechuk** » Thu, May 08 2008, 12:19AM

Hey Mike, place the pipe anywhere in elevation view then hit Esc, then hilite it, from there you can enter your position dimensions.

Mike Snodgrass · Post by **Mike Snodgrass** » Thu, May 08 2008, 4:09PM

Rick, I did this as I have for about 3 years but it isn't showing the dimensions to the left.

Just a note. The snap marker was until I lengthened the wall by 1/2" and then it doesn't either.

I entered three more pipes to see if they would and they wouldn't either.

By the way, I'm liking most of what I'm seeing though!

Sergio Fetter · Post by **Sergio Fetter** » Thu, May 08 2008, 4:20PM

Hey Mike,
Try out in a different job. Sometimes my computer acts crazy for somethings and I just need start all over again.

Thermwood / eCabinet Systems

Positioning water pipe

Positioning water pipe

Re: Positioning water pipe

Re: Positioning water pipe

Re: Positioning water pipe