Positioning water pipe
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 70
- Joined: Mon, Nov 28 2005, 10:12PM
- Location: LUBBOCK, TX
Positioning water pipe
When I select the water pipe in elevation view. It no longer shows up in the positioning boxes. What can I do to get the correct positioning?
-
- Wizard Member
- Posts: 1896
- Joined: Wed, May 18 2005, 7:54PM
- Company Name: Milltech Millworks Ltd.
- Country: CANADA
- Location: Edmonton, Alberta
- Contact:
Re: Positioning water pipe
Hey Mike, place the pipe anywhere in elevation view then hit Esc, then hilite it, from there you can enter your position dimensions.
-
- Junior Member
- Posts: 70
- Joined: Mon, Nov 28 2005, 10:12PM
- Location: LUBBOCK, TX
Re: Positioning water pipe
Rick, I did this as I have for about 3 years but it isn't showing the dimensions to the left.
Just a note. The snap marker was until I lengthened the wall by 1/2" and then it doesn't either.
I entered three more pipes to see if they would and they wouldn't either.
By the way, I'm liking most of what I'm seeing though!
Just a note. The snap marker was until I lengthened the wall by 1/2" and then it doesn't either.
I entered three more pipes to see if they would and they wouldn't either.
By the way, I'm liking most of what I'm seeing though!
-
- Junior Member
- Posts: 92
- Joined: Tue, Jan 23 2007, 12:29PM
- Company Name: Two Mile
- Location: NC
Re: Positioning water pipe
Hey Mike,
Try out in a different job. Sometimes my computer acts crazy for somethings and I just need start all over again.
Try out in a different job. Sometimes my computer acts crazy for somethings and I just need start all over again.
Sergio Fetter
Designer Specialist
Dell Vostro 230 - Intel(R) Core(TM)2 2 Duo CPU E7500 @ 2.93GHz 2.93 GHz
Ram 3GB - Windows 7 32-bit
Designer Specialist
Dell Vostro 230 - Intel(R) Core(TM)2 2 Duo CPU E7500 @ 2.93GHz 2.93 GHz
Ram 3GB - Windows 7 32-bit