Profile Edge

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
leigh mills
Senior Member
Posts: 211
Joined: Wed, Jan 23 2008, 9:49AM
Location: England UK

Profile Edge

Post by leigh mills »

Hi guys,

I have a question about the profile edge. with the profile edge tool I understand that the line leading to the red dot indercates the way the cut will perform but where will the cut start? Is this illustrated by the red dot? Also can you change where the cut will start?

Thanks

Leigh
Top
Post Reply

Return to “eCabinet Systems Software”