Create a round part
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 45
- Joined: Fri, May 18 2007, 9:40AM
Create a round part
I'm tring to create a round part using part editor, but only can do round holes. How does one create a round part, for example a table top?
-
- eCabinets Beta Tester
- Posts: 593
- Joined: Tue, May 17 2005, 12:41PM
- Location: Stamford, CT USA
- Contact:
Re: Create a round part
Draw your circle in the "Contour" section of the part editor
Exit contour mode.
Select "Create part using closed contour" from the right click menu.
click on the circle.
Click on "Next" button at bottom of screen.
Regards,
Dave
Exit contour mode.
Select "Create part using closed contour" from the right click menu.
click on the circle.
Click on "Next" button at bottom of screen.
Regards,
Dave
-
- Junior Member
- Posts: 45
- Joined: Fri, May 18 2007, 9:40AM
Re: Create a round part
Thank you David
David Hall wrote:Draw your circle in the "Contour" section of the part editor
Exit contour mode.
Select "Create part using closed contour" from the right click menu.
click on the circle.
Click on "Next" button at bottom of screen.
Regards,
Dave