Presentation view bug

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Sergio Fetter
Junior Member
Posts: 92
Joined: Tue, Jan 23 2007, 12:29PM
Company Name: Two Mile
Location: NC

Presentation view bug

Post by Sergio Fetter »

I am trying to get some jpg from my job in presentation view. The job is about 32 MB and when I try to place in presentation view, before the rendering finishes, e-cabinets crashes.
Is anyone having the same problem?
Sergio Fetter
Designer Specialist

Dell Vostro 230 - Intel(R) Core(TM)2 2 Duo CPU E7500 @ 2.93GHz 2.93 GHz
Ram 3GB - Windows 7 32-bit
Kerry Fullington
Wizard Member
Posts: 4718
Joined: Mon, May 09 2005, 7:33PM
Company Name: Double E Cabinets
Country: UNITED STATES
Location: Amarillo, TX

Re: Presentation view bug

Post by Kerry Fullington »

Sergio,

Close eCabinets then shut down your computer.
Re-start the computer run eCabinets then open your job and try the Presentation view. Also if you have any pulls on your cabinets, click on the Presentationview Settings button and lower the setting for pulls.

Kerry
Sergio Fetter
Junior Member
Posts: 92
Joined: Tue, Jan 23 2007, 12:29PM
Company Name: Two Mile
Location: NC

Re: Presentation view bug

Post by Sergio Fetter »

Kerry,
Thank you very much for your quick answer.
I have tryed. That worked great. I didn't realize that you could minimize pull details.
Once again, thanks for your great help, you just made some customers really happy.
Sergio Fetter
Designer Specialist

Dell Vostro 230 - Intel(R) Core(TM)2 2 Duo CPU E7500 @ 2.93GHz 2.93 GHz
Ram 3GB - Windows 7 32-bit
Walker T Scott

Re: Presentation view bug

Post by Walker T Scott »

Sergio

Could you send that job to this email address cabinets@ecabinetsystems.com with a note to forward it to me?
Thanks
Post Reply