drilling holes, any ideas?

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Jonathan Lester
Senior Member
Posts: 133
Joined: Thu, May 25 2006, 9:29AM
Location: Carleton Place, Ontario
Contact:

drilling holes, any ideas?

Postby Jonathan Lester » Mon, May 26 2008, 6:45AM

Hello
The company I work for is putting together a manual for assembly so that whn new guys start they wont have to remember all the specific measurements right away hopefully reducing some of the stress to provide a better work environment. So my question is we want to have pictures of gables and other parts and on the picture we want to show when construction holes would be. I know how to do this for hardware holes but can not figure out how to do it for construction holes. Any help would be great.

Mark Hesketh
Guru Member
Posts: 366
Joined: Fri, Aug 25 2006, 9:12AM
Company Name: Paris Kitchens
Country: CANADA
Location: Paris, ontario

Re: drilling holes, any ideas?

Postby Mark Hesketh » Mon, May 26 2008, 8:13AM

By construction holes, do you mean dowel construction?

We use dowel construction on all of our cabinets. I place the holes in part editor, then go into the constraints manager and add the location dimensions. You can always print this screen (I take a screen capture into photoshop and print it from there). You can also take your cabinet into the line drawing editor, hide all the other parts and add your dimensions there.

Hope this helps

Jonathan Lester
Senior Member
Posts: 133
Joined: Thu, May 25 2006, 9:29AM
Location: Carleton Place, Ontario
Contact:

Re: drilling holes, any ideas?

Postby Jonathan Lester » Mon, May 26 2008, 8:30AM

It might. I will give it a try. Thanks


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 38 guests