Drawer box problem in version 5.2 and 5.1

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
DanFecteau
eCabinets Beta Tester
Posts: 276
Joined: Tue, May 10 2005, 12:00PM
Location: St-Odilon, Quebec, Canada
Contact:

Drawer box problem in version 5.2 and 5.1

Post by DanFecteau »

I'm having problem with my drawer, I machine a job, the material is the same for everything so is the setup, 50% dado settings with a 0.025 tolerance but if you look at the drawer tenon thickness in the nest and the dado width, there is almost 1/16" tolerance ?? how come ?
Attachments
test.esj
this is a 5.1 version file
(1.32 MiB) Downloaded 273 times
jerry johnson
Junior Member
Posts: 90
Joined: Wed, Dec 26 2007, 7:52PM

Re: Drawer box problem in version 5.2 and 5.1

Post by jerry johnson »

Hi, Dan. I had the same problem in 5.2 and the guys at Thermwood said there is a problem and they are working on a patch. In the mean time I found that if I set my tennon to 49% everything works OK. Hope this helps. 8)
DanFecteau
eCabinets Beta Tester
Posts: 276
Joined: Tue, May 10 2005, 12:00PM
Location: St-Odilon, Quebec, Canada
Contact:

Re: Drawer box problem in version 5.2 and 5.1

Post by DanFecteau »

Ok thank you, but my partner is still working on 5.1 and he got the same problem ??
Scott G Vaal
Thermwood Team
Posts: 1740
Joined: Tue, May 17 2005, 12:44PM
Company Name: Thermwood Corporation
Location: Thermwood Corp: Dale, Indiana
Contact:

Re: Drawer box problem in version 5.2 and 5.1

Post by Scott G Vaal »

Dan,

I cannot check your job in 5.1 (because it was saved in 5.2), but this issue did exist in 5.1 and 5.2 bld 1. I examined your scenario here and it is the same issue that we have addressed for bld 2.
Regards,

Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Post Reply