Mitering Crown

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

User avatar
Mark Fese
Junior Member
Posts: 64
Joined: Tue, Aug 22 2006, 3:46PM
Location: Elizabeth Lake Ca.

Mitering Crown

Postby Mark Fese » Thu, Jul 03 2008, 5:32PM

hi all, I created this crown and yet having a hard time creating the mitered corners, The crown is for an upper cabinet and has a return on both sides. Any help. thanks Mark.
Attachments
crn test.jpg
crn test.jpg (3.04 KiB) Viewed 998 times
Free Lance eCabinet Designers
ACD All Cabinet Design
www.acdallcabinetdesign.com

Todd Miller

Re: Mitering Crown

Postby Todd Miller » Mon, Jul 07 2008, 8:07AM

Mark,
You will need to create a 45 degree mitre tool.

First, create the molding to your desired length.
Then, take the molding into the PE.
Next, use the 45 degree miter tool to make your mitre cuts on both ends of the part.
Then, go back into the cabinet editor and move the part into position.

Note: when making the 45 degree cuts, you may need to flip the part to get the desired cut.

User avatar
Mark Fese
Junior Member
Posts: 64
Joined: Tue, Aug 22 2006, 3:46PM
Location: Elizabeth Lake Ca.

Re: Mitering Crown

Postby Mark Fese » Wed, Jul 09 2008, 2:10PM

Thanks Tod I will give that a try. Mark.
Free Lance eCabinet Designers
ACD All Cabinet Design
www.acdallcabinetdesign.com


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 21 guests