Write CNC then CRASH!

Thom Davies · Post by **Thom Davies** » Mon, Jul 07 2008, 5:41PM

Hey How's it going?

Some times when i send a job down even if it big or small ecab will some times crash and have reopen it again. The job file(TWD) doesnt get stuffed up so thats good!

Thanks

Thom Davies

Nick M Singer · Post by **Nick M Singer** » Tue, Jul 08 2008, 3:04AM

I second that Thom, same thing happened to me this weekend, programme crashed but the TWD was fine and machined OK

Walker T Scott · Post by **Walker T Scott** » Tue, Jul 08 2008, 6:59AM

Could you post a job that this happens on even if its some times?
Thanks

Michael S Murray · Post by **Michael S Murray** » Tue, Jul 08 2008, 8:16AM

I was having the same thing, but somewhere along the line it seemed to have quit doing it. (knock on wood)

Gary Urlacher · Post by **Gary Urlacher** » Tue, Jul 08 2008, 8:59AM

I have had a problem with 5.2 and 5.1 crashing. I found that it seemed to be related to my computer running 2
monitors. When I do not have the desk top settings set to extend my computer to the second monitor,
it seems more stable. When I have the second monitor, it crashes quite a bit.

Even if I turn off the second monitor and un plug it, it would crash. I had to go to the video settings and
turn off the extend to monitor 2 option for the crashing to stop. This might be a related issue for you as well.

Gary

Thermwood / eCabinet Systems

Write CNC then CRASH!

Write CNC then CRASH!

Re: Write CNC then CRASH!

Re: Write CNC then CRASH!

Re: Write CNC then CRASH!

Re: Write CNC then CRASH!