Part Editor problem
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Senior Member
- Posts: 101
- Joined: Mon, Aug 08 2005, 6:06PM
- Company Name: Scot Acree Woodworkig LLC
- Country: UNITED STATES
- Location: Ohio
Part Editor problem
I can not get the top of this corner base into the part editor.Also tried the sides and back.This is the message I get.I did load a base cabinet and it went to the PE just fine.
- Attachments
-
- ScreenHunter_02 Aug. 06 14.46.gif (8.62 KiB) Viewed 2894 times
-
- part editor test.hsf
- (90.02 KiB) Downloaded 266 times
-
- part editor test.jpg (12.28 KiB) Viewed 2894 times
Re: Part Editor problem
The cabinet has lost some of its bodies to restore them do this. Select the cabinet then select –remove part editor cuts – from entire cabinet from the mouse tire. I’ll look in to this and see what I can come up with for why this happened. Sorry for the inconvenience
Re: Part Editor problem
Scott
Are you still running v5.1build 4 for ecabinets? That’s the version history of this cabinet for the last time it was saved. The problem may have already been fixed in one of the newer versions but ill look at it to make sure.
Are you still running v5.1build 4 for ecabinets? That’s the version history of this cabinet for the last time it was saved. The problem may have already been fixed in one of the newer versions but ill look at it to make sure.
-
- Senior Member
- Posts: 101
- Joined: Mon, Aug 08 2005, 6:06PM
- Company Name: Scot Acree Woodworkig LLC
- Country: UNITED STATES
- Location: Ohio
Re: Part Editor problem
Walker,
that fixed it.I can now take it to the PE.
I am running the latest version of E-Cabs,but on Vista if it matters.
Thank you,
Scot
that fixed it.I can now take it to the PE.
I am running the latest version of E-Cabs,but on Vista if it matters.
Thank you,
Scot