Hey how's it going?
Ok well i started using ecab in nov 04 and that was V3.2 and we are now on 5.2 and i have just started to learn custom layout! and OMG is it wicked! I Love it to bits!
I know im so slow ae! LOL
Im keen to post something 1 day. It be crap compared to every1 else that puts things up on here but i got to start some where! LOL
Cheers
Thom Davies
Im So SLOW!!!
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Guru Member
- Posts: 530
- Joined: Tue, May 17 2005, 6:44PM
- Company Name: Dawn Group
- Country: NEW ZEALAND
- Location: Christchurch New Zealand
-
- Wizard Member
- Posts: 1896
- Joined: Wed, May 18 2005, 7:54PM
- Company Name: Milltech Millworks Ltd.
- Country: CANADA
- Location: Edmonton, Alberta
- Contact:
Re: Im So SLOW!!!
Don't feel bad Thom, I mostly batch my cabs for the cutlist.
-
- Wizard Member
- Posts: 5852
- Joined: Thu, Jul 28 2005, 10:18AM
- Company Name: Dan Epps
- Country: UNITED STATES
- Location: Rocky Face GA
Re: Im So SLOW!!!
Just make sure you rotate the image 180 degrees so it will be upright when viewed in the northern hemisphere Thom.Thom Davies wrote:Im keen to post something 1 day. It be crap compared to every1 else that puts things up on here but i got to start some where!
-
- Guru Member
- Posts: 459
- Joined: Tue, May 17 2005, 4:00PM
- Company Name: TBA
- Country: AUSTRALIA
- Location: ORANGE NSW AUSTRALIA every now and then between trips lol
Re: Im So SLOW!!!
So that explains conventional and climb cutting on my router, it so the bits rotate the right direction when they get down under !!!
This message made from recycled electrons.