back inset
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 68
- Joined: Fri, Jun 23 2006, 9:01AM
- Location: palm harbor, fl
back inset
i need to have a back inset with a cabinet. and i keep getting a message saying i can't be done. can this be done? if so how do you do this. thanks darren
- Attachments
-
- console 1.hsf
- (240.02 KiB) Downloaded 339 times
-
- Guru Member
- Posts: 645
- Joined: Mon, Nov 20 2006, 3:39PM
- Company Name: Rylex Custom Cabinetry-Close
- Country: UNITED STATES
- Location: Pine Island, New York
- Contact:
Re: back inset
Darren,
Are you trying to inset the back on an angle?
Are you trying to inset the back on an angle?
Re: back inset
Darren,
If you want to inset the back, goto construction settings, then the "BACK" tab. Set the "BACK INSET" to whatever you need it to be. If you want to have the part rotated to match the angle on the end panels, you may want to use a stretcher for the back panel. See pic below.
If this is not the answer you were looking or you need further assistance, for let me know.
If you want to inset the back, goto construction settings, then the "BACK" tab. Set the "BACK INSET" to whatever you need it to be. If you want to have the part rotated to match the angle on the end panels, you may want to use a stretcher for the back panel. See pic below.
If this is not the answer you were looking or you need further assistance, for let me know.
- Attachments
-
- back stretcher.JPG (47.36 KiB) Viewed 3520 times
-
- Junior Member
- Posts: 68
- Joined: Fri, Jun 23 2006, 9:01AM
- Location: palm harbor, fl
Re: back inset
what i was doing was giving the deck a back inset then the back a back inset. that's where i was getting the problem. then i left the deck without an inset and gave the back the proper inset, and everything fell into place. thanks darren