Hello,
I am trying to add an image to a wall that will show up through a window cutout.
It is a photo that I have used before and is in Program Files>Thermwood>Ecabinets>Materials. However when I apply it the wall gets an image not found pattern all over it.
Any suggestions?
Thanks,
Joe
Exterior window image
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 73
- Joined: Wed, Nov 30 2005, 9:26PM
Exterior window image
Joseph Murphy
President
Highland Woodworking
Nelsonville, NY
President
Highland Woodworking
Nelsonville, NY
-
- eCabinets Beta Tester
- Posts: 1117
- Joined: Tue, May 17 2005, 9:40PM
- Location: Vista, CA, U.S.A.
- Contact:
Re: Exterior window image
You might want to list the steps you are using to do this. I just tried changing the texture of a wall to a few images and it's working fine.
Joe
Joe
CFT411 http://www.cft411.com
Intel i7 920 @ 2.67GHz, 6 GB RAM, Windows 7 64 bit, NVIDIA Geforce GT220 (1GB)
Intel i7 920 @ 2.67GHz, 6 GB RAM, Windows 7 64 bit, NVIDIA Geforce GT220 (1GB)
-
- Junior Member
- Posts: 73
- Joined: Wed, Nov 30 2005, 9:26PM
Re: Exterior window image
Tried It with different photos and textures and it works fine.
Don't know what was wrong with the original photo.
Thanks,
Joe
Don't know what was wrong with the original photo.
Thanks,
Joe
Joseph Murphy
President
Highland Woodworking
Nelsonville, NY
President
Highland Woodworking
Nelsonville, NY
-
- Guru Member
- Posts: 460
- Joined: Thu, May 19 2005, 3:15PM
- Location: Palm Springs, Ca
- Contact:
Re: Exterior window image
Joe, I believe some photos and images will not load properly unless the pixel dimension sizes can be divisible by four (if I recall correctly). Try re-sizing.
regards,
regards,