KD/RTA Question?

[Damon Nabors]

On the two partitions, I have housing holes but no holes for the pins on the two upper front housings. Also I can not seem to get the KD fasteners to show up on the rear of these partitions. I have tried different offsets but can't seem to get the magic number for them to show up.

[Damon Nabors]

Disregard the Pin Holes. I figured that one out. If you change the opening Height, the Partitions do not resize and therefore they get crammed up into the top stretcher causing a problem with the visibility of the holes. I would still like to know if the KD fasteners could be located on the rear of the partitions without having to manually place them in the parts editor.

Thanks.

[Walker T Scott]

Damon

I’ve been able to reproduce your issue it’s caused by the insets you have for the partitions KD. I have this listed for the programmers. Sorry for the inconvenience.