Something strange about "Change Sheet Stock"

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Lamar Horton
Senior Member
Posts: 222
Joined: Sun, Dec 11 2005, 1:22PM
Location: Kennedale, Texas
Contact:

Something strange about "Change Sheet Stock"

Postby Lamar Horton » Sat, Feb 21 2009, 4:41PM

When changing some sheet stock in a kitchen I am working on I see drawer parts mixed with the pieces of that cabinet. There are no drawer in any of the upper cabinets. When I nest the job, it nests correctly. But when I open the sheet stock changer I see the drawer parts. This is not a problem just something that seems out of place.
Attachments
Clipboard01.jpg
Clipboard01.jpg (253.87 KiB) Viewed 2135 times

Walker T Scott

Re: Something strange about "Change Sheet Stock"

Postby Walker T Scott » Mon, Feb 23 2009, 7:53AM

Could you attach the job and will take a look at.
Thanks

Lamar Horton
Senior Member
Posts: 222
Joined: Sun, Dec 11 2005, 1:22PM
Location: Kennedale, Texas
Contact:

Re: Something strange about "Change Sheet Stock"

Postby Lamar Horton » Mon, Feb 23 2009, 9:10PM

Here it is
Attachments
New Folder.zip
(6.56 MiB) Downloaded 138 times

Walker T Scott

Re: Something strange about "Change Sheet Stock"

Postby Walker T Scott » Tue, Feb 24 2009, 8:26AM

Lamar

This is caused by the drawer box you have in your base cabinets. I’ve tried changing the drawer box material and even changing the drawer box but none of that fixes the problem. I have listed this for the programmers.
Thanks


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 48 guests