Something strange about "Change Sheet Stock"
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Senior Member
- Posts: 222
- Joined: Sun, Dec 11 2005, 1:22PM
- Location: Kennedale, Texas
- Contact:
Something strange about "Change Sheet Stock"
When changing some sheet stock in a kitchen I am working on I see drawer parts mixed with the pieces of that cabinet. There are no drawer in any of the upper cabinets. When I nest the job, it nests correctly. But when I open the sheet stock changer I see the drawer parts. This is not a problem just something that seems out of place.
- Attachments
-
- Clipboard01.jpg (253.87 KiB) Viewed 3481 times
Lamar Horton
http://www.jlcustomcabinets.com
http://www.jlcustomcabinets.com
Re: Something strange about "Change Sheet Stock"
Could you attach the job and will take a look at.
Thanks
Thanks
-
- Senior Member
- Posts: 222
- Joined: Sun, Dec 11 2005, 1:22PM
- Location: Kennedale, Texas
- Contact:
Re: Something strange about "Change Sheet Stock"
Here it is
- Attachments
-
- New Folder.zip
- (6.56 MiB) Downloaded 256 times
Lamar Horton
http://www.jlcustomcabinets.com
http://www.jlcustomcabinets.com
Re: Something strange about "Change Sheet Stock"
Lamar
This is caused by the drawer box you have in your base cabinets. I’ve tried changing the drawer box material and even changing the drawer box but none of that fixes the problem. I have listed this for the programmers.
Thanks
This is caused by the drawer box you have in your base cabinets. I’ve tried changing the drawer box material and even changing the drawer box but none of that fixes the problem. I have listed this for the programmers.
Thanks