Keyholes eCabs and CNC

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

FredHirsch
Senior Member
Posts: 167
Joined: Tue, Oct 03 2006, 6:51PM
Location: Phoenix, AZ
Contact:

Keyholes eCabs and CNC

Postby FredHirsch » Tue, Feb 24 2009, 1:56PM

Wondering if anyone has any ideas how to use a keyhole bit to cut keyholes in the backside of a cabinet back (small cabinet) and send to the machine. This post should also be in 3 Axis area? Could you somehow make a profile bit in part editor, but then the machine ramps in to the cut and I didn't really want to change ramping on the control as we will probably forget to change back. Any ideas?
Thanks,
Fred
Fred Hirsch

Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 3 guests