Hello All
I am working on a bath vanity.
For some reason it keeps crashing when I apply doors and drawer fronts.
It will go through the process of saving itself after I add a door say and then it will stop where is processing the edgebanding, then a pop up will occur
saying "The parameter is incorrect". I have never had this before.
The only thing I did differently this time was to create a stretcher to become a backer for a false drawer ( the drawer front attaches to it ).
When I created the stretcher I had to rotate it as the tenons were biting into the front of my edgebanded case.
Does anyone have any ideas? I am trying to get this out to my cnc guy.
Thanks
Steve WIlliams
"The parameter is incorrect"
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 31
- Joined: Mon, Aug 04 2008, 1:07PM
-
- Senior Member
- Posts: 222
- Joined: Wed, Feb 21 2007, 1:29PM
- Location: STL, MO
Re: "The parameter is incorrect"
Hi Steve,
can you post your files on the forum!
Nemanja
can you post your files on the forum!
Nemanja
-
- Senior Member
- Posts: 209
- Joined: Tue, May 17 2005, 1:05PM
- Company Name: Richmond Cabinet
- Country: UNITED STATES
- Location: Delavan, WI
Re: "The parameter is incorrect"
You don't need to rotate the stretcher. In streatcher editor, select the stretcher and click Construction Settings. Select Construction Parameters for up-down stretchers. Select Tenon Front Side. Your problem should go away.
Dave Egnoski
Richmond Cabinet & Millwork
Richmond Cabinet & Millwork
-
- Junior Member
- Posts: 31
- Joined: Mon, Aug 04 2008, 1:07PM
Re: "The parameter is incorrect"
Thanks David