I am wondering if anyone has a great way of doing toe kicks? If I use ecabs only a front toe is on the cut list. It would be great if it gave a front and back toe. I keep sleepers on hand depending on the depth of the cabinet. I am trying to avoid adding a toe to every cabinet on the job. I have to save as an assembly after adding a toe and this is rather confusing when I am trying to remember where everything is, or I have to make a save file for each job in assemblies as well as cabinet. Any input into this
Thanks,
John
Toe Kick
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Senior Member
- Posts: 242
- Joined: Wed, Oct 24 2007, 9:58PM
- Company Name: American Millwork Company
- Country: UNITED STATES
- Location: Joplin, Missouri
-
- Junior Member
- Posts: 90
- Joined: Wed, Dec 26 2007, 7:52PM
Re: Toe Kick
John, just add a stretcher to the cabinet and it will resize with the cabinet. Then you can use your pre-made sleepers.
-
- Wizard Member
- Posts: 1896
- Joined: Wed, May 18 2005, 7:54PM
- Company Name: Milltech Millworks Ltd.
- Country: CANADA
- Location: Edmonton, Alberta
- Contact:
Re: Toe Kick
John, this is the re-sizable base I use.
- Attachments
-
- Base.jpg (6.66 KiB) Viewed 4194 times
-
- Base.hsf
- (112.02 KiB) Downloaded 305 times
-
- Wizard Member
- Posts: 1896
- Joined: Wed, May 18 2005, 7:54PM
- Company Name: Milltech Millworks Ltd.
- Country: CANADA
- Location: Edmonton, Alberta
- Contact:
Re: Toe Kick
Sorry John, misunderstood the question. If you follow Jerry's method that should work for you. You can also hilite the part and give it a user part name like Rear Toe kick. That will then show up on your cutlist.