Reception desk
Moderators: Jason Susnjara, Clint Buechlein
-
- eCabinets Beta Tester
- Posts: 276
- Joined: Tue, May 10 2005, 12:00PM
- Location: St-Odilon, Quebec, Canada
- Contact:
Reception desk
Reception desk and wall paneling.
- Attachments
-
- Aspec31-03-2003 025.jpg (323.2 KiB) Viewed 6033 times
-
- Guru Member
- Posts: 406
- Joined: Tue, May 17 2005, 12:41PM
- Location: In the Boonies near Oromocto, NB, Canada
-
- Senior Member
- Posts: 121
- Joined: Mon, Jun 13 2005, 12:26PM
- Location: Calverton, New York
- Contact:
-
- eCabinets Beta Tester
- Posts: 276
- Joined: Tue, May 10 2005, 12:00PM
- Location: St-Odilon, Quebec, Canada
- Contact:
Curved front
There's a couple ways to do this. This one was made by \"veining\" the back with a 1\\4\" downcut evey half inch or so. You than apply it to a frame with the form you want.
-
- New Member
- Posts: 1
- Joined: Tue, May 31 2005, 1:21PM
- Location: Anchorage, Alaska
Reception desk
Very nice work.
Was this designed using ecabinets? If so, I'd be inerested in seeing how you did it. I'm still learning the program and always finding new stuff I can do with it.
Thanks,
Willie
Was this designed using ecabinets? If so, I'd be inerested in seeing how you did it. I'm still learning the program and always finding new stuff I can do with it.
Thanks,
Willie