Make a column

Moderators: Jason Susnjara, Clint Buechlein

Paul Huff
Junior Member
Posts: 95
Joined: Thu, May 19 2005, 12:32AM
Location: Lubbock, Texas

Make a column

Postby Paul Huff » Sat, Jan 20 2007, 6:43AM

Ok I am a kid at heart when it comes to some things. Use the dxf or x_t file included in the contours zip to make a column.
Attachments
contour magic.jpg
contour magic.jpg (400.75 KiB) Viewed 1680 times
Make Column.jpg
Make Column.jpg (65.73 KiB) Viewed 1680 times
Contours.zip
(20.21 KiB) Downloaded 131 times

User avatar
Mike Bowers
Wizard Member
Posts: 1346
Joined: Thu, May 19 2005, 9:45AM
Location: Gulfport, Fl.
Contact:

Postby Mike Bowers » Fri, Jan 26 2007, 10:21AM

Nice job Paul
Mike
We love what we do, we do it well.

User avatar
DanEpps
Wizard Member
Posts: 5852
Joined: Thu, Jul 28 2005, 10:18AM
Company Name: Dan Epps
Country: UNITED STATES
Location: Rocky Face GA

Postby DanEpps » Fri, Jan 26 2007, 10:39AM

Here's your challenge Paul:

Change the flutes to concave instead of convex, give the a flat outer surface and make the columns fatter at the bottom than the top--like Greek marble columns. :D

That would be a REAL feat to accomplish!

User avatar
Brian Shannon
eCabinets Beta Tester
Posts: 974
Joined: Thu, May 19 2005, 10:50PM
Location: Los Alamos, CA

Postby Brian Shannon » Fri, Jan 26 2007, 10:48AM

Go Paul, Go! You're an animal!

David Norton
Guru Member
Posts: 710
Joined: Thu, May 19 2005, 11:01AM
Company Name: Custom Trim and Millwork
Country: UNITED STATES
Location: Lawrenceburg,Tennessee

Postby David Norton » Fri, Jan 26 2007, 8:08PM

Damn this is what came to mind when I saw this. Would love to have a .tol file that cut that profile.................hehehe!
Dave Norton

User avatar
Mike Bowers
Wizard Member
Posts: 1346
Joined: Thu, May 19 2005, 9:45AM
Location: Gulfport, Fl.
Contact:

Postby Mike Bowers » Fri, Jan 26 2007, 8:19PM

Welcome back Dave !:beer:
We love what we do, we do it well.

David Norton
Guru Member
Posts: 710
Joined: Thu, May 19 2005, 11:01AM
Company Name: Custom Trim and Millwork
Country: UNITED STATES
Location: Lawrenceburg,Tennessee

Postby David Norton » Sat, Jan 27 2007, 8:19AM

Thx Mike, yea it's been awhile.
Dave Norton

Paul Huff
Junior Member
Posts: 95
Joined: Thu, May 19 2005, 12:32AM
Location: Lubbock, Texas

Postby Paul Huff » Sat, Jan 27 2007, 8:28AM

Hmmm that might be possible with the right tol. I might give that a try.


Return to “Customer Images”

Who is online

Users browsing this forum: No registered users and 4 guests