Radius Bar Rail

Moderators: Jason Susnjara, Clint Buechlein

User avatar
Brian Shannon
eCabinets Beta Tester
Posts: 979
Joined: Thu, May 19 2005, 10:50PM
Location: Los Alamos, CA

Radius Bar Rail

Postby Brian Shannon » Sat, Feb 10 2007, 12:19AM

After lots of trial and error, I finally was able to cut this radius Bar Rail to match a purchased straight rail. My lumber supplier wanted $1280.00 for the radius(12\"). I'll post the tools A.S.A.P., after I'm finished with the Ark. We're expecting LOTS of rain tomorrow. I may post pictures of the Ark too. 'Anyone have plans for Arks? I'm thinking Extira Mdf w/ raised panels.



Brian

User avatar
George Davidson
eCabinets Beta Tester
Posts: 1585
Joined: Tue, May 17 2005, 1:16PM
Location: Norwood Pa.

Postby George Davidson » Sat, Feb 10 2007, 8:11AM

That is nice Brian

User avatar
DanEpps
Wizard Member
Posts: 5852
Joined: Thu, Jul 28 2005, 10:18AM
Company Name: Dan Epps
Country: UNITED STATES
Location: Rocky Face GA

Re:

Postby DanEpps » Sat, Feb 10 2007, 9:28AM

George Davidson wrote:That is nice Brian


Cheap too!!! Very nice Brian.

User avatar
George Davidson
eCabinets Beta Tester
Posts: 1585
Joined: Tue, May 17 2005, 1:16PM
Location: Norwood Pa.

Postby George Davidson » Sat, Feb 10 2007, 9:54AM

How would I find a Thermwood
around me. To go see it work.

I am in Southern Delaware County Pa.
Right by the Philly airport

User avatar
Brian Shannon
eCabinets Beta Tester
Posts: 979
Joined: Thu, May 19 2005, 10:50PM
Location: Los Alamos, CA

Postby Brian Shannon » Sun, Feb 11 2007, 1:07PM

George,

If I were a Wizard, I could maybe figure out how to make and attach a video of this being cut. I did glue up two blocks of wood @ 2 3/4\" thick and only used one. Maybe I should cut it and give it to my supplier to display at their front counter. It's easy now, all the hard work is done! This was all cut with only a 1/2\" endmill cutter.


Brian

User avatar
DanEpps
Wizard Member
Posts: 5852
Joined: Thu, Jul 28 2005, 10:18AM
Company Name: Dan Epps
Country: UNITED STATES
Location: Rocky Face GA

Postby DanEpps » Sun, Feb 11 2007, 1:29PM

Brian

If you have a video file that is small enough to post, just zip it and post it.

User avatar
Brian Shannon
eCabinets Beta Tester
Posts: 979
Joined: Thu, May 19 2005, 10:50PM
Location: Los Alamos, CA

Postby Brian Shannon » Sun, Feb 11 2007, 1:47PM

Well, I didn't video this one but if I cut another I'll have to tape it.

Brian

David Norton
Guru Member
Posts: 710
Joined: Thu, May 19 2005, 11:01AM
Company Name: Custom Trim and Millwork
Country: UNITED STATES
Location: Lawrenceburg,Tennessee

Postby David Norton » Sun, Feb 11 2007, 7:33PM

I want this .tol Brian...................hehehe. Jest what I've been lookin fer!
Dave Norton


Return to “Customer Images”

Who is online

Users browsing this forum: No registered users and 1 guest