Crown Molding_Ceiling

Moderators: Jason Susnjara, Clint Buechlein

Post Reply
George Davidson
eCabinets Beta Tester
Posts: 1585
Joined: Tue, May 17 2005, 1:16PM
Location: Norwood Pa.

Crown Molding_Ceiling

Post by George Davidson »

Crown Molding around Ceiling
It can be resized right now it is set for a room 12' x 12'
Attachments
ceiling molding_12 ft x 7.25 x 12 ft.hsf
(36.02 KiB) Downloaded 677 times
Ceiling Trim_Cr.jpg
Ceiling Trim_Cr.jpg (35.71 KiB) Viewed 9338 times
Sizes.jpg
Sizes.jpg (46.14 KiB) Viewed 9338 times
Greg Whitman
Junior Member
Posts: 31
Joined: Thu, Dec 11 2008, 7:26PM

Re: Crown Molding_Ceiling

Post by Greg Whitman »

Hi George

Thanks for posting the ceiling molding and for that matter everything else you post. It is much appreciated. When I downloaded the ceiling molding to my import file I couldn't get it to open. I got an "error occured while retrieving HOOPS information to the saved file." I don't know if it is something I did or what. Thanks Greg
George Davidson
eCabinets Beta Tester
Posts: 1585
Joined: Tue, May 17 2005, 1:16PM
Location: Norwood Pa.

Re: Crown Molding_Ceiling

Post by George Davidson »

Did you put it into a yellow folder first
or try the room I put it in
Let me know
Attachments
Ceiling Trim.esj
(174.02 KiB) Downloaded 619 times
Peter Walsh
Guru Member
Posts: 460
Joined: Thu, May 19 2005, 3:15PM
Location: Palm Springs, Ca
Contact:

Re: Crown Molding_Ceiling

Post by Peter Walsh »

George,
I got the same result as Greg.
I note that it is an esj file which is a job file. Does a job file call for separate cabinet files to be available for loading or is it all included with the esj file?
regards,
George Davidson
eCabinets Beta Tester
Posts: 1585
Joined: Tue, May 17 2005, 1:16PM
Location: Norwood Pa.

Re: Crown Molding_Ceiling

Post by George Davidson »

Just try the STL they will fall right in place around the room
Attachments
STL Crown Molding_Ceiling.zip
(145.42 KiB) Downloaded 647 times
DanEpps
Wizard Member
Posts: 5852
Joined: Thu, Jul 28 2005, 10:18AM
Company Name: Dan Epps
Country: UNITED STATES
Location: Rocky Face GA

Re: Crown Molding_Ceiling

Post by DanEpps »

Greg Whitman wrote:...When I downloaded the ceiling molding to my import file I couldn't get it to open. I got an "error occured while retrieving HOOPS information to the saved file." I don't know if it is something I did or what. Thanks Greg
Peter Walsh wrote:...I got the same result as Greg.
I note that it is an esj file which is a job file. Does a job file call for separate cabinet files to be available for loading or is it all included with the esj file?
regards,
I'll bet George is posting files created in v6 beta, which cannot be open in v5.2.
Post Reply