Dears..............
plz help me with this error,
i'm trying to make homing but the maching stops and showing,
Error 1514 : B Axis C – Marker adjust value is too largely Negative. Plz report THERMWOOD Corp
Plz help me to rectify this problem.
-
- Advertisement
|
|
|
HOMING ERROR
Moderators: Jason Susnjara, Rich Kasten
3 posts
• Page 1 of 1
HOMING ERROR
by Mohammed riyas » Wed, Jan 04 2012, 7:01AM
- Mohammed riyas
- New Member
- Posts: 8
- Joined: Sun, Jan 01 2012, 3:38AM
- Location: riyadh
- Company Name: ARTIC
- Country: SAUDI ARABIA
Re: HOMING ERROR
by Daniel Vonderheide » Wed, Jan 04 2012, 9:01AM
Mohammed,
The error that you are getting is because there is too large of a value for the B axis in your c-marker adjustment table. If you have a large value in the table because of alignments, you will need to re-belt and realign the axis.
The error that you are getting is because there is too large of a value for the B axis in your c-marker adjustment table. If you have a large value in the table because of alignments, you will need to re-belt and realign the axis.
- Daniel Vonderheide
- Thermwood Team
- Posts: 354
- Joined: Wed, May 17 2006, 11:25AM
- Location: Thermwood
Re: HOMING ERROR
by Mohammed riyas » Thu, Jan 05 2012, 2:41AM
Dear Mr.Daniel Vonderheide,
Thanks a lot for your needfull help.
Thanks a lot for your needfull help.
- Mohammed riyas
- New Member
- Posts: 8
- Joined: Sun, Jan 01 2012, 3:38AM
- Location: riyadh
- Company Name: ARTIC
- Country: SAUDI ARABIA
3 posts
• Page 1 of 1
Return to Thermwood 5-Axis Machinery
Who is online
Users browsing this forum: No registered users and 1 guest