HOMING ERROR

Discuss Thermwood 5-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Clint Buechlein, Jim Bullis

Post Reply
Mohammed riyas
New Member
Posts: 8
Joined: Sun, Jan 01 2012, 3:38AM
Company Name: ARTIC
Country: SAUDI ARABIA
Location: riyadh
Contact:

HOMING ERROR

Post by Mohammed riyas »

Dears..............

plz help me with this error,
i'm trying to make homing but the maching stops and showing,

Error 1514 : B Axis C – Marker adjust value is too largely Negative. Plz report THERMWOOD Corp

Plz help me to rectify this problem.
Daniel Vonderheide
Thermwood Team
Posts: 361
Joined: Wed, May 17 2006, 11:25AM
Location: Thermwood

Re: HOMING ERROR

Post by Daniel Vonderheide »

Mohammed,

The error that you are getting is because there is too large of a value for the B axis in your c-marker adjustment table. If you have a large value in the table because of alignments, you will need to re-belt and realign the axis.
Mohammed riyas
New Member
Posts: 8
Joined: Sun, Jan 01 2012, 3:38AM
Company Name: ARTIC
Country: SAUDI ARABIA
Location: riyadh
Contact:

Re: HOMING ERROR

Post by Mohammed riyas »

Dear Mr.Daniel Vonderheide,
Thanks a lot for your needfull help.
Post Reply