Tool Drop Out

Discuss Thermwood 5-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Clint Buechlein, Jim Bullis

Post Reply
Mohammed riyas
New Member
Posts: 8
Joined: Sun, Jan 01 2012, 3:38AM
Company Name: ARTIC
Country: SAUDI ARABIA
Location: riyadh
Contact:

Tool Drop Out

Post by Mohammed riyas »

Dear's,

plz help us..........!

we are using C67 DT machine.

while in running the machine suddenly stops & shows an emergency alaram. after that we continue's with homing operation and again run the program but the machine shows, "the draw bar is not fully retract & no tool on the spindle ". even tho we tried manually change the tool but their no Change. The spindle is not running but the other axis are moving upto near to Z offset.

if, anybody knows plz help us to rectify the problem.
plz find the attachment too regarding this issue. :(

Image 1.JPG
Image 2.JPG
jason galbraith
Senior Member
Posts: 249
Joined: Wed, Dec 10 2008, 3:29PM
Company Name: Eastcoast Ultimate
Country: AUSTRALIA
Contact:

Re: Tool Drop Out

Post by jason galbraith »

Hi there, probably not much help to you but have you typed in 'draw bar" or similar issue items into the search box? It may help you find a solution.
Core i7-2600 @ 3.70Ghz - 8 GB ram - Win 7 Ultimate 64bit - 2 x 24" ASUS monitors - Nvidia 600 Quadro 1GB graphics
www.eastcoastultimate.com.au
Post Reply