Off-topic discussion that doesn't pertain to the other forums.
Moderator: Jason Susnjara
2 posts • Page 1 of 1
- George Davidson
- eCabinets Beta Tester
- Posts: 1585
- Joined: Tue, May 17 2005, 1:16PM
- Location: Norwood Pa.
Sears Scratch and Dent Warehouse Reg $1200 Sale $100.00
- Sears Scratch and Dent Warehouse.jpg (58.68 KiB) Viewed 1404 times
You'll see these symptoms if your Level of Detail Settings for Custom Layout is turned down or possibly, if your graphics card is just not up to the task. The latter is speculation. You'll get similar unusual looking parts in the Cabinet Editor if the levels are set low. On a side, but related note, one customer installed adjustable shelves but could not see the shelf pin holes. He spent quite a bit of time pondering and redoing. It boiled down to the Level of Detail Settings. He was doing everything else correctly.
Who is online
Users browsing this forum: No registered users and 4 guests