Bar Code Scanner

Off-topic discussion that doesn't pertain to the other forums.

Moderator: Jason Susnjara

Robert Trahan
New Member
Posts: 6
Joined: Mon, Dec 06 2010, 9:36AM
Company Name: First Choice Kitchens
Location: Waterville, Nova Scotia
Contact:

Bar Code Scanner

Postby Robert Trahan » Sat, Dec 11 2010, 10:17PM

Can someone tell me how to use the scanner to read the off fall pieces? when do you actually scan a piece of material?

Thanks,

Rob

Gary Campbell
Guru Member
Posts: 256
Joined: Sat, Apr 04 2009, 6:27PM
Company Name: ShopBot Tools Inc
Country: UNITED STATES
Location: Durham NC

Re: Bar Code Scanner

Postby Gary Campbell » Sun, Dec 12 2010, 12:14AM

Robert...
Are you using Thermwood CN or the SB Link? They may be similar, but I can only explain as it would apply to the SB Link.

When a job is loaded, and before it is nested, Click [Add Sheets] then [Off Falls]
When the Off Falls dialog is open, scan an Off Fall label. That should enter it. You may have to click [Load Selected]
The selected Off Fall must be the same as one of the materials in the loaded job to be used.

Return to main and click Nest in [X] or [Y]. Parts will be nested on your scanned Off Fall(s) prior to full sheets of the same description.

If you are using TWD CN, hopefully one of those guys will chime in.
Gary Campbell
ShopBot Tools Production Support

ShopBot (eCabinets) Link Training & Support


Return to “Lounge”

Who is online

Users browsing this forum: No registered users and 2 guests