Sometimes when I change the style of drawer front I have to redo all the fronts not only the ones I want to change. One of the top fronts will be narrower than the other one. The second one I place will be the narrower one. In this case 436mm vs 428mm. I'm using 16mm material and have a double upper partition.
Any way around this besides just deleting all and starting over?
Off-topic discussion that doesn't pertain to the other forums.
Moderator: Jason Susnjara
2 posts • Page 1 of 1
- Brad McIntosh
- Guru Member
- Posts: 538
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Country: CANADA
- Location: St. Zotique, Québec, Canada
Who is online
Users browsing this forum: No registered users and 5 guests