HardWare Holes

Off-topic discussion that doesn't pertain to the other forums.

Moderator: Jason Susnjara

Nicholas Kiss
Junior Member
Posts: 31
Joined: Wed, Nov 22 2017, 2:09PM
Company Name: Clearcut
Country: CANADA

HardWare Holes

Postby Nicholas Kiss » Wed, Dec 13 2017, 4:13PM

So I've been trying to Predrill my hinge holes on my cabinet but it just makes a small dot on the material I tried editing the hardware hole and change the negative thickness/Positive thickness but nothing changed any help please?
~Nick

Brad McIntosh
Guru Member
Posts: 559
Joined: Wed, May 18 2005, 6:59PM
Company Name: CNC Automation
Country: CANADA
Location: St. Zotique, Québec, Canada
Contact:

Re: HardWare Holes

Postby Brad McIntosh » Thu, Dec 14 2017, 8:56AM

Nicholas,

After modifying the pattern in the Hardware Hole Editor, did you "reapply" the doors? If not, the old pattern is saved with that cabinet and the "disk copy" is not considered in any rebuild.

Contact Jim here at CNC Automation if you need some assistance.
CNC Automation Software Support
Jim Mavrokefalos
(877) 267-5540
jimm@cncautomation.com
Brad McIntosh
CNC Automation

Home: http://www.cncautomation.com
Twitter: @bmcncautomation


Return to “Lounge”

Who is online

Users browsing this forum: No registered users and 5 guests