To make these use a piece of stock 3 1/2 wide X 1 7/8 deep.
There is a PDF included that shows how deep to set each of the bits.
-
- Advertisement
|
|
|
Six Mirror Frames
Moderator: Jason Susnjara
2 posts
• Page 1 of 1
Six Mirror Frames
by Paul Huff » Tue, Jan 02 2007, 8:57PM
- Attachments
-
SixMirFrame.zip- (351.76 KiB) Downloaded 247 times
-
- molding2.jpg (83.7 KiB) Viewed 1115 times
- Paul Huff
- Junior Member
- Posts: 95
- Joined: Thu, May 19 2005, 12:32AM
- Location: Lubbock, Texas
Re: Six Mirror Frames
by justin mason » Sun, Jan 13 2008, 11:54PM
well done paul,
very well put together, I think I will use one of these tools this week.
thank you for sharing the hard work.
JM
very well put together, I think I will use one of these tools this week.
thank you for sharing the hard work.
JM
clear design
- justin mason
- Junior Member
- Posts: 43
- Joined: Fri, Jan 20 2006, 11:31PM
- Location: Redmond, wa 98052
- Company Name: IWS
- Country: UNITED STATES
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest