Milling Aluminum

Moderators: Jason Susnjara, Clint Buechlein

Post Reply
Wade Huggins
New Member
Posts: 1
Joined: Fri, Jan 12 2007, 4:25PM

Milling Aluminum

Post by Wade Huggins »

I'm trying to mill some offset fixtures out of aluminum plate and I've already gummed up one bit. What is a good bit, spindle speed, feed rate, and bite per pass for such an operation?
Roger Erismann
Senior Member
Posts: 169
Joined: Sun, Dec 04 2005, 11:42PM
Location: Sacramento, CA and Rolla, Mo

Post by Roger Erismann »

you might try the Thermwood forum
Wood Butcher/Case Maker
Post Reply