RN manual

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Jeff Norris
Guru Member
Posts: 321
Joined: Fri, May 20 2005, 1:44AM

RN manual

Postby Jeff Norris » Wed, Oct 12 2005, 4:15PM

is there any additional imformation on the layers for RN since pocketing operations were enabled? the one i have is from 3.85

User avatar
Paul Ford
eCabinets Beta Tester
Posts: 632
Joined: Wed, May 18 2005, 1:18AM
Location: Rotorua - NewZealand
Contact:

Postby Paul Ford » Wed, Oct 12 2005, 7:09PM

Hi Jeff,
Aparently Ryan is working on an updated manual as we speak. I have asked for them to post it on here when it is finished which was going to be yesterday afternoon. Hopefully tomorrow it might be here.
I have a manual for V4.74 attached. I haven't had a chance to read it yet so you can have a look through it and see if it is of assistance to you.

Jeff Norris
Guru Member
Posts: 321
Joined: Fri, May 20 2005, 1:44AM

Postby Jeff Norris » Thu, Oct 13 2005, 9:03AM

thanks paul


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 7 guests