HELP offset error

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Jason Rains
New Member
Posts: 14
Joined: Tue, Mar 18 2008, 1:08PM

HELP offset error

Postby Jason Rains » Mon, Nov 09 2009, 8:03AM

Hi guys, I need some help adjusting my offset settings. When I try to set my offsets an error occurs and shuts down the program. Any suggestions?
Thanks

Ryan Hochgesang

Re: HELP offset error

Postby Ryan Hochgesang » Mon, Nov 09 2009, 8:17AM

If you are using the G52L# method for offsets, it is likely your offset table has been corrupted. To correct this issue, you will need do the following once you've written down any offsets that you can access in the table:

Shutdown the Thermwood software > Go to Windows Explorer > find C:\offset.tab directory, Delete file THM.OFF > Then restart the Thermwood software and you should be able to enter values in the offset table.

Jason Rains
New Member
Posts: 14
Joined: Tue, Mar 18 2008, 1:08PM

Re: HELP offset error

Postby Jason Rains » Mon, Nov 09 2009, 9:03AM

Thanks Ryan, I'll try it.


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 6 guests