Can't Nest !!!

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

DanFecteau
eCabinets Beta Tester
Posts: 258
Joined: Tue, May 10 2005, 12:00PM
Location: St-Odilon, Quebec, Canada
Contact:

Can't Nest !!!

Postby DanFecteau » Thu, Mar 11 2010, 12:49PM

I had control nesting 5.52 and I was not able to nest this job, same problem with 5.53....help please. The .doc is the twd file.
Attachments
Meuble.doc
(288 KiB) Downloaded 60 times
Meuble.esj
(1.63 MiB) Downloaded 51 times

Ryan Hochgesang

Re: Can't Nest !!!

Postby Ryan Hochgesang » Thu, Mar 11 2010, 1:42PM

Dan,

Could you please explain in more detail what's happening or what error your getting? I will also need a copy of your EXPORT file from Control Nesting for review here. You can send this information to: program@thermwood.com

Thanks!

Ryan Hochgesang

Re: Can't Nest !!!

Postby Ryan Hochgesang » Thu, Mar 11 2010, 2:32PM

Dan,

Perform the following steps with the TWD software shutdown:

1.) Delete c:\Rolling Nest\history.mdb (DELETE only the "history.mdb"
file)
2.) Run Latest install (Full or Repair)
3.) Start Control Nesting and go into SETTINGS and change the "Keep Recut
History" to zero

DanFecteau
eCabinets Beta Tester
Posts: 258
Joined: Tue, May 10 2005, 12:00PM
Location: St-Odilon, Quebec, Canada
Contact:

Re: Can't Nest !!!

Postby DanFecteau » Thu, Mar 11 2010, 2:57PM

Problem fixed !! Thank you.


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 2 guests