Measure tool error?
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Senior Member
- Posts: 179
- Joined: Thu, Oct 11 2007, 7:33PM
- Company Name: Penn Laminates
- Country: UNITED STATES
- Location: Trafford PA
- Contact:
Measure tool error?
When I use "Maintenance Tool Unload" to return a bit to the typewriter head to take out a dull bit and use "Maintenance Tool Load to return a new bit to the spindle I'm getting an error when I go to measure that bit. It says " Invalid AFL statement, maybe files may be open" I read it twice to make sure I was reading it right! Then I have to exit Supercontrol and restart it then I can measure the bit as usual without the error.
-
- Thermwood Team
- Posts: 46
- Joined: Fri, Mar 16 2007, 7:46AM
Re: Measure tool error?
Hello Terry, What version of THM software is on your control currently? Try pressing "Ctrl" and "V", it should pop up on the screen. Thanks
Thermwood Technician
-
- Senior Member
- Posts: 179
- Joined: Thu, Oct 11 2007, 7:33PM
- Company Name: Penn Laminates
- Country: UNITED STATES
- Location: Trafford PA
- Contact:
Re: Measure tool error?
Carl,
ver 7.4.5.10 installed about 2 months ago.
ver 7.4.5.10 installed about 2 months ago.
-
- Thermwood Team
- Posts: 46
- Joined: Fri, Mar 16 2007, 7:46AM
-
- Thermwood Team
- Posts: 46
- Joined: Fri, Mar 16 2007, 7:46AM
Re: Measure tool error?
Hello Terry, what is a good number that I can reach you? I will call you. Thanks
Thermwood Technician
-
- Senior Member
- Posts: 179
- Joined: Thu, Oct 11 2007, 7:33PM
- Company Name: Penn Laminates
- Country: UNITED STATES
- Location: Trafford PA
- Contact:
Re: Measure tool error?
Hi Carl,
(724) 925-9100
(724) 925-9100