Measure tool error?

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Terry Davis
Senior Member
Posts: 168
Joined: Thu, Oct 11 2007, 7:33PM
Company Name: Penn Laminates
Country: UNITED STATES
Location: Trafford PA
Contact:

Measure tool error?

Postby Terry Davis » Mon, Apr 19 2010, 1:28PM

When I use "Maintenance Tool Unload" to return a bit to the typewriter head to take out a dull bit and use "Maintenance Tool Load to return a new bit to the spindle I'm getting an error when I go to measure that bit. It says " Invalid AFL statement, maybe files may be open" I read it twice to make sure I was reading it right! Then I have to exit Supercontrol and restart it then I can measure the bit as usual without the error.

Carl Jones
Thermwood Team
Posts: 46
Joined: Fri, Mar 16 2007, 7:46AM

Re: Measure tool error?

Postby Carl Jones » Wed, Apr 21 2010, 2:37PM

Hello Terry, What version of THM software is on your control currently? Try pressing "Ctrl" and "V", it should pop up on the screen. Thanks
Thermwood Technician

Terry Davis
Senior Member
Posts: 168
Joined: Thu, Oct 11 2007, 7:33PM
Company Name: Penn Laminates
Country: UNITED STATES
Location: Trafford PA
Contact:

Re: Measure tool error?

Postby Terry Davis » Wed, Apr 21 2010, 4:00PM

Carl,
ver 7.4.5.10 installed about 2 months ago.

Carl Jones
Thermwood Team
Posts: 46
Joined: Fri, Mar 16 2007, 7:46AM

Re: Measure tool error?

Postby Carl Jones » Thu, Apr 22 2010, 6:36AM

Thanks Terry, I will get back to you asap on this.
Thermwood Technician

Carl Jones
Thermwood Team
Posts: 46
Joined: Fri, Mar 16 2007, 7:46AM

Re: Measure tool error?

Postby Carl Jones » Thu, Apr 22 2010, 8:17AM

Hello Terry, what is a good number that I can reach you? I will call you. Thanks
Thermwood Technician

Terry Davis
Senior Member
Posts: 168
Joined: Thu, Oct 11 2007, 7:33PM
Company Name: Penn Laminates
Country: UNITED STATES
Location: Trafford PA
Contact:

Re: Measure tool error?

Postby Terry Davis » Thu, Apr 22 2010, 10:04AM

Hi Carl,
(724) 925-9100


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 4 guests