1991 C50 w/ 9100 control

ryan westfahl · Post by **ryan westfahl** » Tue, Nov 01 2005, 6:53PM

I am purchasing a 1991 C50 with 9100 control. With this machine I would like to do 2d profile and 3d contour machining. I am under the impression that the control is quite capable however I do not know what cam software or post processor to utilise. Any suggestions would be very much appreciated.

Thanks

ryan

Ryan Hochgesang · Post by **Ryan Hochgesang** » Wed, Nov 02 2005, 3:36PM

Hi Ryan,

Master Cam is a very good program for 2D and 3D machining and is proven with Thermwood machinery. If you contact us here at Thermwood, we will be glad to discuss in greater detail.

Phone: 1 800 221 3865