Can the machine convert "vector based files" and successfully machine them? The file is from an illustrator package. If so, how?
Also, it goes on a sign so any suggestions for machining hdu board would be helpful.
Rob
convert vector language
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis
-
- Thermwood Team
- Posts: 818
- Joined: Tue, May 17 2005, 1:32PM
- Company Name: Thermwood Corporation
- Country: UNITED STATES
- Location: Thermwood
Re: convert vector language
Hello Rob,
Thermwood's Gen2 control should be able to nest and cut the files if they are a layered dxf. As for as how that's done, you'll need to contact our service dept and ask for a programming assistance.
When machining HDU board, most of the tooling developed to machine plastic works very well. Your tooling vendor may carry a line of tools specifically for machining plastic, if not, Thermwood may offer what you need.
Dennis.
Thermwood's Gen2 control should be able to nest and cut the files if they are a layered dxf. As for as how that's done, you'll need to contact our service dept and ask for a programming assistance.
When machining HDU board, most of the tooling developed to machine plastic works very well. Your tooling vendor may carry a line of tools specifically for machining plastic, if not, Thermwood may offer what you need.
Dennis.
Re: convert vector language
Hi Rob,
Below is a link to Thermwood's on-line Control Nesting Manual. Here you can read about the Control Nesting software which is a standard option on the Thermwood control (THM version 5.05+). You will find specific information regarding dxf files and how to setup layer names for the nested base software. Once you've had a chance to look it over, give us a call (1800 221 3865) or email us(program@thermwood.com) and we will be glad to further assist you.
Link:
http://order.ecabinetsystems.com/update ... Manual.htm
Below is a link to Thermwood's on-line Control Nesting Manual. Here you can read about the Control Nesting software which is a standard option on the Thermwood control (THM version 5.05+). You will find specific information regarding dxf files and how to setup layer names for the nested base software. Once you've had a chance to look it over, give us a call (1800 221 3865) or email us(program@thermwood.com) and we will be glad to further assist you.
Link:
http://order.ecabinetsystems.com/update ... Manual.htm