Labels again

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Dave Burtchell
Junior Member
Posts: 98
Joined: Thu, Jun 30 2005, 10:04PM

Labels again

Postby Dave Burtchell » Sat, Nov 05 2005, 4:55PM

Howdy,

Cutting 12 sheets with about 15 parts per sheet. All .dxf files. Starting with sheet 7, the labels started to get goofy. Only about 50% matched. Using 4.77

Anybody?

Dave

Ryan Hochgesang
Thermwood Team
Posts: 681
Joined: Wed, May 18 2005, 8:41AM
Location: Thermwood

Postby Ryan Hochgesang » Mon, Nov 07 2005, 9:03AM

Hi Dave,

Control Nesting V4.79 has been released, run the update and if you are still seeing the label issue, attach your dxf files and the qty that you nested, and we'll check into the situation.
Ryan Hochgesang
Software Support


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 3 guests