CV V5.65 adding Cut Through Depth

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Jim Bullis

Post Reply
Joe Soto
Guru Member
Posts: 367
Joined: Thu, May 19 2005, 7:50PM
Company Name: Fancyridge Wood Products LLC
Location: Greensburg, Ky

CV V5.65 adding Cut Through Depth

Post by Joe Soto »

Cn is adding the cut through depth setting to chain commands (compin and compout) at the last line of feed even though the chains are not set to outline depth.

Thanks,
Joe
Top
Ryan Hochgesang

Re: CV V5.65 adding Cut Through Depth

Post by Ryan Hochgesang »

Thanks for the info. Joe. I have reproduced the issue your seeing and submitted to our engineering dept. for fix.
Top
Post Reply

Return to “Thermwood 3-Axis Machinery”